my dev.tools - FNIRSI 2C23T 3-in-1 Dual Channel Oscilloscope/Multimeter/Signal Generator

FNIRSI 2C23T 3-in-1 Dual Channel Oscilloscope/Multimeter/Signal Generator


Steps to upgrade of FNIRSI 2C23T 3-in-1:


Remark@2024-03-23:
Please check the comment by dmitriivanov5330 in the video.
How to distinguish the hardware? please press menu , and if you can see the words in Setting: "Hardware version No.:XXXXX " then the device is made with latest hardware, it has the latest firmware, and now it doesn't need to upgrade. 
If you can not see the words in Setting: "Hardware version No.:XXXXX ", then it is made with old hardware, and it can be upgraded with firmware 2.0.2, and if you confirm this, the firmware for the device with old hardware is attached. 
By the way, the firmware 2.0.2 only fixes device with old hardware. The device with new hardware can not use this firmware to upgrade.

- Download firmware from FNIRSI Official Web Site
- Connect USB to PC
- While 2C23T is OFF, press and hold MENU button, then press POWER button to power-on in firmware upgrade mode. 2C23T will appear as USB driver.
- Copy the firmware to USB driver of 2C23T.
- 2C23T will restart after upgraded.


2C23T Signal Generator function test

Just try the signal Generator function of FNIRSI 2C23T, monitored with 2C23T itself and Scoppy Oscilloscope App (+ Raspberry Pi Pico)



Comments

  1. Mohamed Salman August 6, 2024 at 12:34 PM

    Hi,

    I recently tried to update the firmware on my FNIRSI 2C23T 3-in-1 device. Unfortunately, after completing the update, the device powered off and now won’t turn back on. My PC does not detect the device anymore.

    Here’s what I’ve observed:

    When I disconnect the battery and plug the device into the PC, a green LED lights up.
    When I reconnect the battery and then plug the device into the PC, the LED stays red.
    Has anyone experienced a similar issue or have any suggestions on how to resolve it? Any help would be greatly appreciated!

    Thanks in advance.

    ReplyDelete

Post a Comment

Popular posts from this blog

480x320 TFT/ILI9488 SPI wih EP32C3 (arduino-esp32) using Arduino_GFX Library

Image
Display on 3.5 inch 480x320 TFT with SPI ILI9488 (SKU:MSP3520) with XIAO EP32C3 (arduino-esp32) using Arduino_GFX Library. Install GFX Library for Arduino (Arduino_GFX) in Library Manager. Arduino_GFX is a Arduino graphics library supporting various displays with various data bus interfaces. This library start rewrite from Adafruit_GFX, LovyanGFX, TFT_eSPI, Ucglib, and more... Connection:      Connection between XIAO ESP32C3 and      3.5" 480x320 TFT with SPI ILI9488 (SKU:MSP3520)      XIAO ESP32C3                        +-------------+           +---------|GPIO2    5V      |          | +-----|GPIO3    GND    |-----------+ | +-|-----|GPIO4    3V3    |---------+ | | | | +---|GPIO5    GPIO10|-----...
Read more