Download code to CH582F (RISC-V) using MounRiver Studio v1.84/WCHISPStudio V3.40, on Windows 11.

For WeAct Studio CH582F (RISC-V) BLE5.3 Core Board :

There are two approach to download code to CH582F
i - ISP (In-System Programmer) : via onboard USB using WCHISPStudio. CH582F have to be set in Boot mode (press & hold BOOT button, then connect USB to onboard USB port).
ii - With WCHlink Debugger using MounRiver Studio Flash funtion directly. Two-line debug interface have to be enable in-advance.

In my test:
With MounRiver Studio v1.84 installed on Windows 11, WCHISPStudio V3.40, and USB driver installed also. That means I have no need to download and install WCHISPStudio and USB driver separately.

Connect WeAct WCHlink to CH582F as:

WCHlink    CH582F
3V3        3V3
DIO        B14
CLK        B15
GND        GND


Github WeActStudio/WeActStudio.WCH-BLE-Core
https://github.com/WeActStudio/WeActStudio.WCH-BLE-Core


Comments

Post a Comment

Popular posts from this blog

480x320 TFT/ILI9488 SPI wih EP32C3 (arduino-esp32) using Arduino_GFX Library

Image
Display on 3.5 inch 480x320 TFT with SPI ILI9488 (SKU:MSP3520) with XIAO EP32C3 (arduino-esp32) using Arduino_GFX Library. Install GFX Library for Arduino (Arduino_GFX) in Library Manager. Arduino_GFX is a Arduino graphics library supporting various displays with various data bus interfaces. This library start rewrite from Adafruit_GFX, LovyanGFX, TFT_eSPI, Ucglib, and more... Connection:      Connection between XIAO ESP32C3 and      3.5" 480x320 TFT with SPI ILI9488 (SKU:MSP3520)      XIAO ESP32C3                        +-------------+           +---------|GPIO2    5V      |          | +-----|GPIO3    GND    |-----------+ | +-|-----|GPIO4    3V3    |---------+ | | | | +---|GPIO5    GPIO10|-----...
Read more

my dev.tools - FNIRSI 2C23T 3-in-1 Dual Channel Oscilloscope/Multimeter/Signal Generator

Image
FNIRSI 2C23T 3-in-1 Dual Channel Oscilloscope/Multimeter/Signal Generator Steps to upgrade of FNIRSI 2C23T 3-in-1 : Remark@2024-03-23: Please check the comment by dmitriivanov5330 in the video. How to distinguish the hardware? please press menu , and if you can see the words in Setting: "Hardware version No.:XXXXX " then the device is made with latest hardware, it has the latest firmware, and now it doesn't need to upgrade.  If you can not see the words in Setting: "Hardware version No.:XXXXX ", then it is made with old hardware, and it can be upgraded with firmware 2.0.2, and if you confirm this, the firmware for the device with old hardware is attached.  By the way, the firmware 2.0.2 only fixes device with old hardware. The device with new hardware can not use this firmware to upgrade. - Download firmware from FNIRSI Official Web Site - Connect USB to PC - While 2C23T is OFF, press and hold MENU button, then press POWER button to power...
Read more